Paver sealing for Highlands homes
Paver Sealing in Highlands, FL
Highlands pavers near Ray Greene Park can get a clean wash and fresh sealer; call (904) 830-5386 for a free estimate.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Fast, careful paver sealing in Highlands
Paver sealing is available across Highlands, from the streets near Ray Greene Park to the blocks along Dunn Avenue. A local contractor washes, re-sands and seals drives, walks and patios, and the estimate is free. After you request your free estimate, a reply arrives inside 1 business day, and usually much sooner.
Maybe your driveway has baked to a flat, pale shade, with orange freckles near the sprinkler heads and sand gone from the joints. Washing, new sand and a coat of sealer return that drive to a single, even shade. If you would like to talk first, call (904) 830-5386 and tell the contractor what the drive looks like today. You will get a price before any work is agreed.
Why hire a local paver sealing contractor in Highlands?
Highlands homes go back to the 1940s and 1950s, so the pavers out front were often added by someone long after the house was built. To learn how that changes a job near your block, request your free estimate. The call is free, and nothing is decided until you say so.
See it before you pay
A contractor walks the Highlands lot and gives you a price. Nothing moves forward without your yes.
A range to measure by
Highlands quotes can be checked against the published Northeast Florida range, $1.75 to $3.25 per square foot to clean, sand and seal.
Think about the tires
A wet look shows wear in drive lanes sooner than matte, a Jacksonville company says. Ask which finish suits the cars parked on your drive.
Decide on your schedule
Pick the date and the finish, or pass. A Highlands estimate asks nothing of you.
Get Your Free Estimate in Highlands
Tell us about your pavers in Highlands.
Free, no obligation
What paver problems show up most in Highlands?
Sun that flattens open drives
Jacksonville's July highs average about 92 degrees, and a driveway with no tree cover takes all of it. A local company says sun fades unsealed concrete pavers within 3 to 5 years. Safe Touch says full sun can push resealing nearer every two years. Open drives and wide front walks are the surfaces that fade first. A sealer coat helps hold the color, and the contractor can tell you where your drive stands before you decide. Resealing is typically every three to five years across Jacksonville, and closer to three on driveways, one cost guide says. A drive that bakes all day can look bleached long before the joints fail, so color is often the first thing owners notice.
Sand that leaves with the storms
Highlands sits on Duval County sand, which drains quickly. Most of Jacksonville's 52 inches of yearly rain arrives between May and September in short, heavy bursts. Those bursts can wash sand out of joints, and bare joints invite soil and weeds. Sealer keeps new sand from leaving next summer.
Pavers added to a 1950s house
A home data page lists East Highlands houses built from 1946 on, with a median year built of 1957. Pavers on those lots were usually laid later, by different owners at different times. That leaves mixed sand, mixed repairs and sealer nobody wrote down. The contractor checks what is on the surface first, because a water-based coat cannot be laid over a solvent-based one. Bring any receipt or product name you find. A newer walkway beside an older drive can sit side by side on one lot.
Green film on the shaded side
Algae grows where shade and moisture meet, and the north side of a building is a common spot. A walkway beside the garage can stay damp long after the drive has dried. Sealer laid over film traps it, so the washing is thorough. The strip along a north wall is the first place to look.
Oil spots and tire marks
Cars live on Highlands driveways, and oil drips collect near the garage door. A Jacksonville company says oil and rust spots are pre-treated before sealing, though some deep stains will not come out completely. It helps to point out the spots at the first visit. Oil near the garage door is common, so mention it when you call. Cars parked in the same spot every day leave the same marks, so the spot by the garage door is the one to point out.
What kind of homes does a contractor see in Highlands?
Mostly modest homes from the post-war years, judging by one data page. It lists 435 homes in East Highlands built between 1946 and 2022, with a median build year of 1957. Streets such as Monaco Drive, De Paul Drive and Pheasant Drive are on that list. Call (904) 830-5386 and tell the contractor roughly when your house and your pavers went in.
ZIP 32218 is large, at nearly 97 square miles, and it counted 67,040 people in 2020. About 67 percent of occupied homes are owner-occupied, and the median home value was $288,100 in 2024. Zoned schools include Garden City Elementary, Highlands Middle and First Coast High. If you are not sure your street falls in this area, you can request your free estimate and ask.
Dunn Avenue is the main road through the area. Highlands Regional Library sits at 1826 Dunn Avenue, and the FSCJ North Campus is off the same road near I-295. A job near a busy road may need an early start, so call (904) 830-5386 and ask about timing. Ray Greene Park, at 2149 Leonid Road, is a short drive away and has soccer fields and basketball courts.
What does paver sealing cost in Highlands?
Published quotes across Northeast Florida for a clean, sand and seal come to $1.75 to $3.25 per square foot. In Highlands, a wide, sunny drive can cost more in total than a short one, even at the same rate. request your free estimate and get a price for the pavers at your house, free of charge. Small side walks measured in with the drive can change the math.
Prep is the swing factor within that range. Oil spots, green film, thin sand and old coats each add hours. A repair for a sunken area adds more, and access can matter too. A call to (904) 830-5386 is enough for the contractor to sort out which of these fit your drive.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $525 to $975 |
| 600 sq ft | Two car driveway | $1,050 to $1,950 |
| 1,000 sq ft | Large driveway or pool deck | $1,750 to $3,250 |
| 1,500 sq ft | Driveway plus pool deck | $2,625 to $4,875 |
Math based on the $1.75 to $3.25 per square foot that Northeast Florida paver companies published as of November 2026. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.
How does a paver sealing job work in Highlands?
Study the drive
The contractor starts at the garage door and works toward the street. Oil spots, sunken areas and old repairs are marked. A sunken area is repaired before sealing, since a coat over it would keep the dip. Anything you know about past sealer helps, and sprinkler zones are worth a mention too.
Lift the film and the oil
Green film from the shaded side comes off in the wash, and tire marks go with it. Oil and rust spots get pre-treated first, though some deep stains may not come out completely. The wash also takes sand from the joints. Rinse water stays off the garage door and plants where it can.
Top off the joints
New sand goes in until every joint is full. Highlands sits on fast-draining sand, so empty joints invite soil, and weeds follow. Per a Jacksonville company, sand goes in first and sealer second, never the reverse. Edges near the garage get a second look. A narrow side yard or a locked gate adds carrying time, so mention access.
Pick a dry day
Summer storms in Jacksonville come in short bursts, and the shaded side of a house dries slowly. Sealer needs a dry surface. One Jacksonville company traces most white or cloudy sealer to damp pavers. Moving the date costs less than a cloudy coat. Fall after hurricane season and spring before the humid months are both popular sealing windows, one cost guide says.
Roll on the finish
Sealer goes on by spray, and a roller follows to work it into the joints. A wet look shows wear in drive lanes sooner than matte. Companies in this area usually run two to five years between coats. Foot traffic usually resumes within a few hours, with cars kept off for about a day. Keep the product name handy for the next coat.
Complete paver services in Highlands
Four steps make up a Highlands job. The wash removes film and oil, new sand fills the joints, the pavers dry, and sealer goes on. Skipping ahead would trap dirt under the sealer, so the order stays fixed. If oil spots need pre-treating, ask when you call (904) 830-5386.
Highlands drives collect oil, sun and tire wear. Side walks next to the garage stay cool and damp, and back patios gather leaves. Name the ones you have when you request your free estimate, and the quote will reflect each surface instead of a rough guess about the whole lot.
Sealer choice has two parts. First comes the old coat, since a water-based product will not go over a solvent-based one, and then comes the look. Matte suits daily parking, while a wet look deepens color but shows lane wear sooner. Call (904) 830-5386 to compare finishes for your Highlands house.
Summer sets the pace. Jacksonville's July highs average about 92 degrees, and most of its rain arrives from May to September in short storms. Pavers must be dry before sealer goes on, and shaded spots take longest. To pick a day that works for your street, request your free estimate.
Questions to ask before you hire
- Is fall or winter a good time to seal here, or should I wait for spring?
- Do the people working at my house carry workers' comp as well as liability coverage?
- Can my family keep swimming while you seal the deck around the pool?
- Will the orange stains my sprinklers leave on the pavers come back after you clean them off?
- If my neighborhood has a gate, do I need to add your name to the guest list?
- Will you text me when you are on the way?
- Will bike tires and sidewalk chalk leave marks on the sealed pavers?
What do sealed pavers look like around Highlands?
Why local matters in Highlands
A contractor who works Highlands knows the sand drains fast and the summer sun is hard on an open drive. That shapes how much sand goes back and how soon a coat may need redoing. Someone from across town may not plan for either. For a contractor who works the Dunn Avenue side of the Northside, call (904) 830-5386.
Local experience helps with older lots too. Many Highlands houses date to the 1950s, so the pavers out front were often added later. A contractor who knows that expects mixed work and checks for old coats first. You can request your free estimate and ask how that check works.
Timing matters on a busy road. Dunn Avenue carries traffic past the library and the college, and a contractor who works here plans arrivals around it. The sealing day also follows the forecast. If that sounds useful, request your free estimate and mention your preferred days.
Is it worth hiring someone who knows Highlands and Dunn Avenue?
Yes, because the area has its own history. Ray Greene Park opened in 1957 and nearly quadrupled in size with 30 acres added in 1976 and 1977. It is named for C Ray Greene Sr., a pharmacist who ran Brentwood Pharmacy and served as a county commissioner. If you live near the park, request your free estimate and name your street.
Other landmarks sit close by. Highlands Regional Library is on Dunn Avenue, the FSCJ North Campus opened in 1970, and Jacksonville International Airport opened in 1968. The state has also proposed a traffic signal at Dunn Avenue and Braddock Road for $3.9 million. Near any of these Highlands landmarks, call (904) 830-5386 and say which street you are on.
Frequently Asked Questions
How much does it cost to re-sand and seal pavers in Highlands?
Across Northeast Florida, companies print $1.75 to $3.25 per square foot for cleaning, sanding and sealing. A wide Highlands drive adds up to a larger total than a short one. Have the total square footage listed in the quote, then compare it with that range.
Why is paver sealing so expensive in Highlands?
Prep eats most of the budget. Film, oil and sunken areas take more time than spraying does, and a failed old coat must come off first, which adds cost. In return you get a surface that holds sand and color for years.
How many years between coats on a Highlands driveway?
Companies usually quote two to five years between coats, though full sun can shorten that. Safe Touch puts the typical figure at every two to three years. A bead of water sitting on the pavers means the coat still works. A wet look on a drive that sees daily tires may need redoing sooner than matte.
What do professionals use to clean pavers in Highlands before sealing?
The contractor picks a wash method to suit the pavers. Oil and rust spots are pre-treated first, though some deep stains may not come out completely. Washing pulls sand from the joints, so it is replaced before the coat goes on. Ask which method the contractor plans to use on your surface.
Does it pay to seal pavers in Highlands?
Yes for most drives. A coat locks the sand into the joints, so weeds have less room, and it shields the color from the sun. A Jacksonville company says sun fades unsealed concrete pavers within 3 to 5 years. The cost is upkeep, since a coat wears out and needs redoing.
What are the downsides of sealing pavers in Highlands?
The main downsides are upkeep and timing. A wet look shows wear in drive lanes sooner than matte, and every coat needs a dry surface. Rain in the Highlands summer can push a date back, though sealing is still worth it for many drives.
Will oil and tire marks come off Highlands pavers before sealing?
Often, but not always. Oil and rust spots are pre-treated before sealing. A Jacksonville company says some deep stains will not come out completely, so point out the worst spots at the first visit. Bring photos if the marks are in several places.
Is matte or a wet look better for a Highlands driveway?
Matte is the quieter pick for a drive. A wet look deepens color but shows wear in drive lanes sooner. Matte is also the safer finish near a pool, and it hides scuffs from daily parking.
What happens with orange sprinkler stains on Highlands pavers?
Orange streaks usually come from irrigation water high in iron, and University of Florida extension notes that most Florida well water is. The contractor pre-treats rust spots before sealing, though some deep stains may not come out completely. Point out your sprinkler zones at the first visit.
When is the right time of year to seal pavers in Highlands?
One Jacksonville cost guide names two good windows: fall, after hurricane season, and spring, before summer humidity peaks. Either way the pavers have to be dry. A shaded Highlands walk may need a longer wait after rain.
How soon can brand-new Highlands pavers be sealed?
Wait first. New pavers need 30 to 60 days before a first sealing, according to a Jacksonville company, so efflorescence can come out. After that window, the joints are filled and the coat goes on. Whoever laid the pavers can confirm the date they went in.
Why did the coat on my Highlands drive turn milky?
Cloudy or milky sealer usually means damp pavers or too heavy a coat, a Jacksonville company says. Speak up as soon as you see haze. Sealing on a dry day is the main prevention.
Ready for a Free Estimate in Highlands?
Call (904) 830-5386 and tell us about your pavers.
Free, no obligation